Change ITG speed and duplex settings 1

[ReenaS]

If I wanted to increase the speed to 100baseT and full duplex on my ITG cards. What would be the ITG shell command and format to do so through a telnet session?

 

[Reusser]

For 100BaseTX TLAN operation, the standard I/O filter connector must be
replaced with the NTCW84JA ITG Line-specific I/O filter connector for the
following:
• the leftmost of the two card slots occupied by the ITG-P 24-port line card
• the slot occupied by the Succession Media Card

CAUTION
For Large systems manufactured between 1998-1999
and shipped in North America, the IPE modules have the
NT8D81BA Backplane to I/O Panel ribbon cable
assembly with a non-removable filter connector. The
NT8D81BA is compatible with a 10BaseT TLAN, but if a
100BaseT TLAN is required, order the NT8D81AA
Backplane to I/O Panel ribbon cable assembly to replace
it. Do not install the NTCW84JA ITG-specific filter
connector onto the existing non-removable filter
connector.

 

[ReenaS]

This sounds more like hardware config than the SW that I need. I am running an Option 11c release X25

 

[ipeology]

tLanSpeedSet Set the TLAN ethernet speed
tLanDuplexSet Set the TLAN ethernet duplex mode

you do not need the i/o filter connector if your running opt11c.

you also need to reboot the card in order for the new settings to take effect.

cheers.

 

[ReenaS]

Thank you very much jpeoplogy and all for your valuable input. You all are just terrific.