Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Change CTYPE

Status
Not open for further replies.

Baitshopboy

IS-IT--Management
Aug 22, 2012
42
US
I need to change the card type from MSDL to TMDI and I understand I need to out the D-channel. I'm getting an error saying that I cant out the D-channel when B-channel is still defined for loops associated with this D-channel. It's been a while since I've done this. I don't remember what to do next. I want to say I have to go in LD 14 but I'm now sure. If anyone could provide the commands that would be great.
 
Ive already got the ADAN for the dch saved for when I need to rebuild it.
 
Are there 23 trunks configured now? If so you can go into LD 14 and do an out 23 and remove them all at once.
 
You may need to out the route also after the trunks are removed
 
Yes, there are 23 trunks now. What are the commands in ld 14? How do I remove the route too?
 
if they are DID then LD 14
req out 23
type did
tn <loop ch> (first channel and it deletes the next 22 as well)

Shouldn't need to do the route as once the members are gone the DCH is no longer associated with one. Then you should be able out out the DCH
 
So, I've successfully outed the dch/loop and recreated as TMDI card. However, when I go to enl tmdi in 96 I get error msdl028.
MSDL0028
Cannot enable the card because it is not present in the system.
If the card in question is believed to be present, check if the switch
settings on the card agree with the device number entered in this
command.
Severity: Minor

I was getting this when I tried to enable it as an msdl card too. Any thoughts?
 
Yeah. I had it in the wrong slot. I moved it to main cabinet in slot 1 and I can communicate with it. BUT I'm getting sdl2110 reason 1 error when I try to enable it using enl tmdi x fdl
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top