Cell Antennae Unit

[warriors]

I have a Definity G3csi v.10. I have connected a cell antennae unit to my existing wireless base (this is the third CAU connected). What programming is needed on the switch? Are these units plug and play? Any instructions would be a great, great help.
Thanks.

 

[Phoneguy15]

Warriors,
There is administration that needs to be done.
You will need to do:
"change radio xxxx (radio controller board location)"
You will then have a page that looks like this...


change radio-controller 1c06 Page 1 of 1

RADIO CONTROLLER CIRCUIT PACK RC Location: 01C06
WFB A PARAMETERS
Internal Antenna? n
WFB Location: 7th floor
CAU Conn? CAU Location
1 y 7th floor north
2 y 7th floor south
3 y 7th floor east
4 y 7th floor west


WFB B PARAMETERS
Internal Antenna? n
WFB Location: hotwater heater room back door
CAU Conn? CAU Location
1 y east side
2 n
3 n
4 n


Depending on the WFB (Wireless Fixed Base Unit) that you connected the CAU to (A or B), you administer the connection for it.

-Todd

 

[Phoneguy15]

Warriors,
Here is a link to some documentation for it also....

http://support.avaya.com/edoc/docs/defgwire/dwguide5.pdf

Look around page 55 or so.


-Todd

 

[warriors]

Thanks Phoneguy15,
The only other step I had to take was to busyout, reset and release the Radio-Controller board (I had a red light on the WFB)and it works fine.