CDR (SMDR) Port Settings on G3SiV9

[rstockton]

Greetings,

I'm implementing Call Accounting and need the correct Port Settings for the CDR (SMDR) port on a G3SiV9. The port settings I'm looking for are the Data Bits, Parity, Flow Control, etc...

Thanks In Advance

 

[Guest_imported]

8 bit no parity 1 stop

 

[bowz]

I put together my own VB program to capture the CDR information.... I put it under the "I have CDR source software in VB" Thread #690-81662 post. Check it out if you want.

 

[rstockton]

Thanks,

Send me the .exe if you want - rstockton@allenedmonds.com.

Say, I'm having trouble receiving the data into hyperterm (read: no data being received) I take it CDR needs to be set to EIA. Is there are CDR "service" that needs to be started on the Definity?

 

[Jolagues]

Yes you need to Go into the trunk groups and turn on cdr reports.

José B. Olagues
Telephony Administrator
NACIO Systems

 

[rstockton]

Thanks,

I'll give that a try when I'm in the office next week.