CDR Setup for G3R r9 with 8400b data module

[kenpitchford]

Let me 1st say I'm sorry this is so long but I wanted to provide as much detail as I could. I guess my main question in all of this is can someone with the same setup show me how they have their's configured? My main question I think is on the TN726/553 administration.

I've been reading in this forum trying to figure out what I'm missing. According to a previous post: In thread690-818306 by 4merAvaya (TechnicalUser)
I have most everything right I think.

I have the TN726/553 packs. But I'm not sure if the are "Administered correctly"

The 8400B is connected to a TN2224. The Data Module's RS-232 connector is connected to a Omnitronix Data-Link DL50 buffer box. I can set this in bypass mode and see anything hitting the Data Module.

Here are my current settings for the 8400B Registers.
AT&V
ACTIVE PROFILE:
B1 E1 L2 M1 Q0 V1 X4 Y0 &C0 &D0 &G0 &J0 &L0 &P0 &Q0 &R0 &S0 &X0 &Y0
S00:001 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:060
S08:002 S09:006 S10:014 S12:050 S14:AAH S16:01H S18:000 S21:00H
S22:76H S23:1BH S24:01H S25:005 S26:001 S27:40H

If I unplug the Data module from the TN2224 the system calls back because I get a record on my buffer box so I believe that the G3R is trying to establish a connection to the the Data-Module

But when I stat the CDR it shows

CDR LINK STATUS
Primary Secondary
Link State: down down
Number of Retries: 1 9999
Maintenance Busy? No No


And on stating the Data Module is shows:
Status Data Mod 7006

DATA-MODULE STATUS
Data Ext/Stn Ext for Stn DM: 6699
Port/Channel Number: 02A0423
Service State: in-service/idle
Maintenance Busy? no
CF Destination Ext:
Connected Ports:

Shouldn't there be a Connected port?
If I call 7006 it is busy. This would indicate that the system has made a connection right?

Sorry this was so long but I wanted to show what I've tried to do so far.

Thanks for any help!!

 

[wilsontec]

have you setup packetdata to dataline path . because g3r data cannot direct connect packet path to tdm path.

 

[kenpitchford]

I looked up packetdata and dataline in the Release 9 library and nothing. Can you tell me where I should look for this?

 

[busster]

If I remember correctly, the packs have to be properly cross-connecte to each other as well.

 

[kenpitchford]

I believe that is in place. Is there any programing necessary to enable the "internal connection from the processor to the 553 to the 726 to the data module." ?