CDr output for HiPath 4000V4

[badrikali]

Hi,

I would like to have the CDR output to be connected to a hyperterminal for a HiPath4KV4 system.

I have done the following:

FEASU - activated CDROGTR
created FTBL table
added SELG and directed to DEV2
in GEZU DEV2 is directed to TERM2
Activated SELS.
FEACG is also activated.


I am checking with the ComWin a direct connection via Atlantic LAN and PORT 1202. I do not get any output, however, i am able to communicate with AMOs on this port.

Please let me know if i have to do anything more for CDR output.

Regards
Sundar

 

[tars]

Make sure you have selg pointing to the right line out in ATCSM, and also make sure the output is activated.
you can act deact with amo LSSM.

 

[hp4krookie]

CDR on the Hp4k only outputs over the IP service port.

connect via 192.0.3 telnet port 1201.

If all is set right, there are several AMO's.

 

[chafchinko]

f all AMO's is set right
connect via 192.0.3 telnet port 1202 if you use DEV2 in selg prog.

 

[badrikali]

Thanks Guys.

The problem was the SELG not pointing to the correct output. It works very well.

Thanx for all the help!

Regards
Sundar