CDP using SIP on CS1000E with NRS to BCM450 get ERR404

[bobertb]

I have just set up SIP networking between a BCM450 and CS1000E Rls6.
Extreeemely Painful I might add.
Anyway it works...4 digit dial back and forth.
Except....
The CS1000E also has a T1 (not PRI) TIE line to another site.
User at CS1000E dials 8xxxx (ie.83731)and call completes over TIE.
User at BCM450 dials same number (8xxxx)and gets ringing.
o 8 is the ACOD for the TIE
o Call has gone out the BCM450 over SIP
o The SIP DCH on the CS1000E shows as below
o Get the ERR404
o The call just continues to ring
Any Ideas???

**** DCH Messaging on CS1000E SIP DCH*************
>>> DN 1199 is on BCM450
>>> DN 83731 is x3731 at another site via ACOD 8
***************************************************
DCH 10 IMSG SETUP REF 00008181 CH 112 0 15 0 TOD 15:10:19
FEAT :CRID
FEAT :NAS
CALLING #:1199 NUM PLAN: PRIVATE/ABBREVIATED (CDP)
CALLED #:83731 NUM PLAN: PRIVATE/ABBREVIATED (CDP)

DCH 10 OMSG CALLPROC REF 00008181 CH 112 0 15 0 TOD 15:10:19

DCH 10 OMSG PROGRESS REF 00008181 CH 112 0 15 0 TOD 15:10:19
PROGRESS: CALL IS NOT END TO END ISDN

DCH 10 IMSG PROGRESS REF 00000188 CH 112 0 15 7 TOD 15:10:19
PROGRESS: INBAND INFO OR PATTERN IS AVAIL

ERR404 0

 

[Tman45]

I think it is just that you don't have a default route setup for it? See error below. Sorry T1 routing is not my specialty.

ERR0404 No default tree exists.
Action:
Severity: Minor. Critical to Monitor: No. SNMP trap: Yes

Its a minor issue as if this route fails its just saying it doesn't have another route to complete the call over - I think ...

 

[MikeRizz]

I had the same issue, try this ( worked for my site ):

I had to add a CRNO entry in LD 49. There were none programmed, so I copied the only FCR entry my other CS1000M 5.0 switch had and added:

CODE
REQ prt
TYPE fcr
CUST 0
CRNO 0

CRNO 0
INIT ALOW