Cause #102, Recovery on timer expiry

[usmcjohn]

I have a trouble where I am dropping calls only from off-site and exactly 3 minutes after the setup message. I have an Option 81c/3.0 and am connected to a GTD5. Below are a couple examples. Is this a telco trouble or could it be a timer on my side?

DCH 0 UIPE_IMSG CC_SETUP_IND REF 00005B5A CH 8 11 TOD 7:17:35 CK 15120372
CALLED #:830xxxx NUM PLAN: E164 TON: LOCL
PROGRESS: ORIGINATING END IS NOT ISDN
CALLING #:NO DIGIT NUM PLAN: UNKNOWN TON: UNKNOWN

DCH 0 UIPE_IMSG CC_DISC_IND REF 00005B5A CH 8 11 TOD 7:20:36 CK 1517815A
CAUSE: #102 - RECOVERY ON TIMER EXPIRY

DCH 0 UIPE_IMSG CC_RELEASE_CONF REF 00005B5A CH 8 11 TOD 7:20:36 CK 1517819C


DCH 0 UIPE_IMSG CC_SETUP_IND REF 00007EDE CH 56 21 TOD 8:22:57 CK 15898369
CALLED #:830xxxx NUM PLAN: E164 TON: LOCL
CALLING #:919649xxxx NUM PLAN: E164 TON: NATL

DCH 0 UIPE_IMSG CC_DISC_IND REF 00007EDE CH 56 21 TOD 8:24:57 CK 158D36F1
CAUSE: #102 - RECOVERY ON TIMER EXPIRY

DCH 0 UIPE_IMSG CC_RELEASE_CONF REF 00007EDE CH 56 21 TOD 8:24:57 CK 158D3747

 

[mluckie1]

You said these are tandem calls? The clid should be going out as NATL and be 10 digits. Would need to see rli for cdp or location code. Check rdb on both system for TIMR TFD (timed force disconnect). This should be 0. The Release command is coming from the CO so look at CLID first. Calls placed from local site work correctly?

 

[usmcjohn]

They are inbound calls from the CO. I don't see a TFD field in the RDB under the timers.

TIMR ICF 512
OGF 512
EOD 13952
NRD 10112
DDL 70
ODT 4096
RGV 640
FLH 510
GRD 896
SFB 3
NBS 2048
NBL 4096

 

[mluckie1]

How are the RDB's set on both ends?