Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

cat 6 cable with cat 5 ends

Status
Not open for further replies.

Fixin

Vendor
Mar 12, 2004
263
US
If I use cat 6 cable with cat 5 ends ( jacks ) will it slow down cat 6 capabilities?
 
Careful with that 'IS', I belive Beldin's upper Cat6 is 22.5, and Krones AirES Cat6 is 24. As well as others.

Justin T. Clausen
Physical Layer Implementation
California State University, Monterey Bay
 
it is possible to use mismatched category products and still pass even the cat 6 tests if your cable is short enough the moon is in the right phase. I think the bigger issue might be that Cat 6 was implemented to provide a medium to allow particular applications. those applications, which include gigabit and maybe upcoming 10gig, will probably operate marginally at best on this configuration. If the original post -er is using it to run 10/100 mb apps, he probably could have used cat 3 jacks on a cat4 cable and not known the difference. (Yes I know Category 4 no longer exists and no one makes it anymore). The point is I think the question was asked even though the answer will have no revelance to the end user asking it. If you are going to do an install and try to get away with using some lower rated items like this one, the better cable is not a bad investment. most of your labor is involved in running and dressing the cables. If the user needs to upgrade the channel later to be compliant, all he needs to do is change the jacks and patch panel then add some cat 6 patch cords and he's in there!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top