Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CAP Module

Status
Not open for further replies.

maggs1717

Programmer
Jun 21, 2007
10
US
I am trying to add a 2nd CAP module to a DN. I am unable to get the system to recognize the 2nd module i.e CAP. I have tested the CAP individually and it is a working unit. I have the DN in system programming set as having a CAP assigned to it. Is there something I am missing?
 
I have 24V on the second pair and do have power to the existing CAP, but not the 2nd one.
 
If its a 4 pair cable W/B pair would be the Set, W/O pair would be the first Cap, and W/G pair would be the second cap. As said above polarity sensitive. Negative ring. A SAP can be used for two Caps.
 
You need a 6-pin line cord. It's a USOC standard, TDM on pins 4,5, power for 1st CAP on 3,6 and power for 2nd CAP on 2,7. Polarity sensitive, positive to tip.

Adversity is Opportunity
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top