I am trying to add a 2nd CAP module to a DN. I am unable to get the system to recognize the 2nd module i.e CAP. I have tested the CAP individually and it is a working unit. I have the DN in system programming set as having a CAP assigned to it. Is there something I am missing?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CAP Module
- Thread starter maggs1717
- Start date
RikRodgers
Vendor
Power?
You need 24v on the second pair. It is polarity sensitive.
You need 24v on the second pair. It is polarity sensitive.
- Thread starter
- #3
Deweyhumbolt
Technical User
You need a 6-pin line cord. It's a USOC standard, TDM on pins 4,5, power for 1st CAP on 3,6 and power for 2nd CAP on 2,7. Polarity sensitive, positive to tip.
Adversity is Opportunity
Adversity is Opportunity
- Thread starter
- #6
- Status
Similar threads
- Locked
- Question