Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

cant hyperterminal into opt11c

Status
Not open for further replies.

mikethephoneguy

Technical User
Sep 15, 2006
95
CA
trying to hyperterminal into an 11c using port 0 NORTEL null modem through a db 25 to db 9 connector with no joy.

any suggestions?

thanks in advance

Mike
 
Try Port 1 or 2 to see if you can isolate the problem?

--
GHTROUT.com - Help for Nortel Meridian/CS1000 System Administrators
--
 
make sure your terminal emulation is set to vt100 or some other vtxxx instead of the default ansi. port 1 and 2 are usually 2400 baud, port 0 is whatever the faceplate is set too, or just use 9600 n-8-1.
 
make sure your 25/9 connector is not a nul modem connector or cable as well. You should be able to take a standard 25/9 modem cable, put a null modem on either side and connect directly to your laptop. make sure your baud rate setting is correct for the port, usually 9600 and it should work. if it hasn't been connected to anything for a long time, it should still work, but you may try an INI, but I doubt you would need to.

John
 
Thanks for all the help it was a bad SDI port on the 11c cabinet....
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top