Can't get workink ANI and DID simultaneously.

[AraBakunts]

Hello,
We have Modular ICS 5.0 with DTI (T1) card installed on. If we set line 002 to DID only, everything is fine. But when try to enable ANI on the same line then DID future doesn't work. ICS receives DTMF digits (ANI/DNIS) wich send CO in this format *ANI*DNIS*.
Any idea?
Thanks in advance.

 

[jerryreeve]

This is out of the 5.0 installer guide

"Remote access on Direct Inward Dial (DID) trunks
Remote system access on DID trunks is similar to that of E&M
trunks connected to a private network.
The main differences are:
• a remote caller is on the public network dialing standard
local or long-distance telephone numbers
• the digits received are delivered by the central office
• DISA cannot be administered to a DID trunk
As with a private network, the dialed digits may be
programmed to match those of a specific target line DN, the
DISA DN or the Auto DN."

JerryReeve
Communications Systems Int'l
com-sys.com

 

[mikescience]

You want to set each channel to E&M with Auto answer Y answer with DISA N, and ANI y. This will solve the DID with ANI issue as well as you can make outgoing calls if you want over this channels.
Take Care,
Mikescience

 

[PERRYPJ]

jerry, mike the guy is saying dnis not disa

OLD ROLMEN WORKING ON NORTELS

 

[AraBakunts]

Thanks a lot Mike. We got an ANI/DNIS by changing DID lines to E&M Wink ...

 

[jerryreeve]

Sorri fer confooshon, aint learnt to reed yet.

JerryReeve
Communications Systems Int'l
com-sys.com