Can't end card

[pawshman]

peeps,

having a problem killing off a card,

Allop shows
cla 4 269

only one channel on syedp
1-0-40-00 48

ROEQE wont work, ( no ROU or TRU figure)
CNBOE wont work (individual still initiated)
tried RFBOI as well, before doing above
need to kill the alarm, obvisuly not properly uninstalled

any ideas

ta

 

[parnum]

when have had this before it needed SACOS as only fix

best parnum

 

[pawshman]

yep think your right,

do you(anyone)know what the SACOS is ?

ta

BC7 <GULP>

 

[pawshman]

<BUMP>

anyone ?

thankxs

 

[trrep]

hi,

do you had have aDPNSS connection on the board befor ?
do you want to have a comlete fix or just want to use the board position again ?

if you need a complete solution we have to check a lot off pointers.
if you just want to use the bpos again try:
sacop:unit=dcp,lim=1,filno=1,point=80&81,off=6;

remember the values !
set the value found in point=81 as data into point=80,
sacos:unit=dcp,lim=1,filno=1,point=80&81,off=6,data= ?;

try syedp again. if free try cnboe.
if it is not free in syedp, set the original value (printed in sacop befor )back.
good luck