I'm unable to remove multiple entries from the SNMP Traps page in CM. Upon checking each checkbox and clicking Delete, I receive an error stating that I've made no selections (e.g. it's like I've clicked Delete without choosing an entry to delete, but that's not the case). Is there a way to delete entries from the SNMP Traps table from CLI instead?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Can't delete SNMP Traps in CM
- Thread starter smitj11
- Start date
- Thread starter
- #3
Hmm, entries in almsnmpconf =/= the SNMP Traps page in CM. Apologies, I'm no Avaya expert and our setup is a bit of a blackbox in terms of all of the VMs in play. We've got a handful of G430's that I'm trying to get to send SNMP alarming to the CM server, but they don't always seem to get through--or they seem to take a long while to get through--even though I can see them getting sent when I sniff out the packets coming out of the G430. Perhaps I'm thinking about this wrong? The SNMP Traps page in CM is where the G430's IPs and communities should go, is it not?
- Status
Similar threads
- Locked
- Question