Can't create a VPDN interface, please help...

[Amakusa42]

Oops! Good point... Sorry, i am new to this whole Cisco thing.

I have a Cisco 2611 router with two ethernet ports. I intend internet service to come into e0/0 and connect to my switch (catylist 2900 in port e0/1) to provide internet service to five devices (two wireless, three wired). I have DHCP assigned on E0/1 to distribute private ip addresses for my home network, so they acquire, but they don't connect.

Now the modem is a Westell Wirespeed, and currently uses a PPPoE connection to connect to Verizon. I know I am supposed to use VPDN to create a PPPoE connection on e0/0, but, for some reason I can't figure out, whenever I use the VPDN command on my router, I get this:

JohnRouter(config)#vpdn enable
^
% Invalid input detected at '^' marker.

(that's supposed to be under the 'p' in vpdn)

For some reason, I can't make a VPDN connection. I don't have SDM for the router, is there some other way to make a PPPoE interface?

 

[burtsbees]

Post a sh ver

Burt

 

[Amakusa42]

Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.3(19), RELEASE SOFTWARE (fc2)
Technical Support:

http://www.cisco.com/techsupport

Copyright (c) 1986-2006 by cisco Systems, Inc.
Compiled Fri 12-May-06 04:13 by evmiller
Image text-base: 0x80008098, data-base: 0x80CE6684

ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
ROM: C2600 Software (C2600-I-M), Version 12.3(19), RELEASE SOFTWARE (fc2)

JohnRouter uptime is 2 days, 7 hours, 19 minutes
System returned to ROM by power-on
System image file is "flash:c2600-i-mz.123-19.bin"

cisco 2611 (MPC860) processor (revision 0x202) with 28672K/4096K bytes of memory
.
Processor board ID JAB032104WU (2604062827)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
2 Ethernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

Thanks for the help, I dont have SDM unfortunately.

 

[burtsbees]

You need an IOS upgrade for the vpdn config, but you are very limited at 8/32...maybe IOS Plus...

Burt

 

[Amakusa42]

Thank you... Is there any other way? I've seen prices for IOS plus and its rather expensive. I got these used, so I dont think I can upgrade for free.

 

[burtsbees]

Perhaps...email me
timandlizh at gmail

Burt