It seems no matter what jack i plug into, whether it's 01 or any other jack set as "manager" or "operator" i can only access the first 14 programming functions. If i enter a 3-digit number higher than "014" i get three beeps. If anyone knows why this is it would be super helpful becuase i'm having problems with a line and really need to get into the 400's. thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
can't access full programming mode D816
- Thread starter UberrRich
- Start date
bigglesnz11
Technical User
Insted of ** + Password, try *# + Password
- Thread starter
- #4
- Thread starter
- #6
The manual definitely doesn't call that installer mode. But unessesary confrontation aside, when i tried that it didn't work. i still get three beeps. When i was initially setting up the system i thought maybe that was just programming mode for the 1232 model and not the D816. But now that you guys have inspired me to re-read it, i see that program ** is called USER programming mode.
so maybe someone changed the password ? is there a way to reset it without resetting everything to factory default?
so maybe someone changed the password ? is there a way to reset it without resetting everything to factory default?
- Thread starter
- #7
Ok maybe i don't need programmer mode. Here is my seemingly simple problem.
I have three Co lines. Incoming calls to CO 2 seem to be sent somewhere, like when you have the line set to go to a specific extemsion.
The phones don't ring, the light (7425 and 7433) is solid red not flashing. If i want to pick up that incoming call i have to use the "40" command to answer a call going somewhere else.
I've made sure i try a phone in each jack and none of them pick up the call automatically.
so apparently i have a CO line that sends the call to some mysterious place, when i want it to act like all the other lines and just ring so i can pick it up.
I have three Co lines. Incoming calls to CO 2 seem to be sent somewhere, like when you have the line set to go to a specific extemsion.
The phones don't ring, the light (7425 and 7433) is solid red not flashing. If i want to pick up that incoming call i have to use the "40" command to answer a call going somewhere else.
I've made sure i try a phone in each jack and none of them pick up the call automatically.
so apparently i have a CO line that sends the call to some mysterious place, when i want it to act like all the other lines and just ring so i can pick it up.
- Thread starter
- #8
- Thread starter
- #10
- Thread starter
- #12
Hey let me throw one quick question in here at the end if i can.
i want to set a button to intercom everyone. i can set buttons to call single extensions. i set up a group because i think i need to make button to page a group, but i only see the program 99 + 1 + extention no. command which doesn't work.
i want to set a button to intercom everyone. i can set buttons to call single extensions. i set up a group because i think i need to make button to page a group, but i only see the program 99 + 1 + extention no. command which doesn't work.
- Thread starter
- #15
- Status
Similar threads
- Locked
- Question