Cannot utilize all licenced VoIP trunks on BCM-200

[michaelnsullivan]

I have three BCM's connected with Voip trunks. the BCM-50 has 2 VoIP trunks and one BCM-200 has 4 and one 32.
I am placing calls between the 200 with 4 trunks and the other switches( only 2 to the BCM-50), but the 4th call receives a fast busy as if there are no trunks available but the monitor only shows three in use. It does not matter which other switch the 4th call is placed to. It blocks to either one.
Anyone know of a problem on the BCM-200 that all trunks cannot be used? I also has QoS monitor turned off, so that it does not impact that calls, switches are local on 100M connections, so not an issue. I can max the trunks on the BCM-50. Any Ideas?

 

[biv343]

All trunks are in the same line pool I'm assuming?

Are you "tandeming" calls from one site to another? If so, might be a TRO/TAT issue.

 

[acewarlock]

Yes I would check each VOIP trunk to see what POOL it is in, as that would stop the 4th trunk from working if it's in the wrong POOL.

 

[michaelnsullivan]

thanks guys

you were right, one trunk had gotten placed in the wrong pool. works now.

thanks