cannot setup sip in SOE

[calin84]

cannot make it work both ways,
I have SOE ip office, Curry IP, Netgear Prosecure UTM10,
I can dial out, incoming do not work, anybody has any info how to setup the Netgear UTM10 for IP office.
Thanks.

 

[hairlessupportmonkey]

either a NAT issue, or you need to run the STUN client on the IPO.

 

[Bas1234]

Call Curry IP, ask to what port they are sending the the RTP stream.

From inside to outside the avaya uses 49152-53247
Most providers use a other range from outside to inside.

Best thing to do is;

Change the RTP range in the Manager (LAN1 or 2) from inside 1-on-1 to the ones Curry uses. Also you're NAT ports in the FW needs to be changed then.

___________________________________________
It works! Now if only I could remember what I did...

Dain Bramaged
___________________________________________

 

[calin84]

I run stun



SIP carrier is Intelechoice(CurryIp)
IPO Small edition 4.2
Cable ISP
Netgear Prosecure UTM10, I forward ports
This is what Curry IP ask me to do.
You may also consider opening the following ports in your router.

Port 7 Echo
3478 => SIP UDP Port used for STUN requests from the IP Office to the SIP provider.
5060 <= => SIP UDP/TCP* SIP Line Signaling
49152 to 53247* <= => RTP/RTCP UDP Dynamically allocated ports used during VoIP calls for RTP and RTCP traffic. The port range can be adjusted through the System | Gatekeeper tab.
can someone tell me how to program the router.

 

[calin84]

I took my system to another location and worked, the ISP cablevision in NY block all incoming.