Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cannot remove operator 3

Status
Not open for further replies.

runlun

IS-IT--Management
Dec 12, 2006
106
NO
Hi

When we should remove all 6 operator from the Md110 TSW SP6, it went wrong with the last one. It is in at status of busy, and I am not able to remove with the opere-command. No help in restarting the ELU28-card, nor blocking the unit or the card
Can anyone help me?

Regards RunLun
 
Restart DOM, DOR, OLP1T and OLP1d. Most probably the busy info is in DOM or/and OLP1T....
 
Ok, thanks, I will try restarting this evening

Rgds
RunLun
 
It just worked fine by restarting these units, thanks a lot[bigsmile]

RunLun
 
runlun, was that worthy of a star then?
 
runlun was apparently not impressed enough that fcpli dug him out of the mire and fixed his problem to award a star, so I will give it a star as I believe fcpli posted good advice.
 
Yes and I give himdp a star for that comment. Word to people asking for help, you won't get any if you do not bother to thank people for helping you, we offer our knowledge for free, you could at least thank people/respond when someone helps you,

Best parnum
 
fcpli: of course it was worht a star, sorry about that - i will give you a star now
himdp/parnum: generally I agree with you, but I am not the type of person that do no appreciate goot help form ohters, sorry about not following up this thread
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top