Cannot out a CDP in LD 87 due to Undef Steering Code error 3

[techdgrubbs]

Hi all,

Here is a print out of the cdp in question, but it keeps giving me an error of esn131, or Undefined steering code. The whole reason why I'm trying to remove it is because the extension cannot be called like other extensions can be.


MEM AVAIL: (U/P): 46731835 USED U P: 5404891 645351 TOT: 52782077
DISK SPACE NEEDED: 933 KBYTES
REQ prt
CUST 0
FEAT cdp
TYPE dsc
DSC 1901
DSC 19
FLEN 4
DSP LSC
RLI 31
NPA 904
NXX 81919
---------------------------------------------------------

error when trying to out:

REQ out
CUST 0
FEAT cdp
TYPE dsc
DSC 1901

ESN131
TYPE ***
OVL000
>err esn131
>

ESN0131
Undefined steering code (CHG command). <<<<<< Why is is saying this?

Severity: Info

 

[bignose21]

the print out to me suggests the DSC is 19 not 1901

in LD 20 just print the DNB for 19 to confirm

 

[KCFLHRC]

bignose21 is correct. The DSC is 19, not 1901. So everything 19XX is pointed to that CDP entry

 

[techdgrubbs]

Thanks Bignose21 and KCFLHRC.


>ld 20

PT0000
REQ: prt
TYPE: dnb
CUST
DN 19
DATE
PAGE
DES

CUST 00

NO ACT SINCE NO DATE

NACT

 

[KCFLHRC]

Print CDP Entry 19 in LD 87

 

[KCFLHRC]

You should also be able to out CDP entry 19.

But when you do you will have to build everything back

So if you out CDP Entry 19 you will have to build back with a whole bunch of entries like

1902
1903
1904
1905
1906
1907
1908
1909
191
192
193
194
195
196
197
198
199

If still needed for CDP

 

[Firebird Scrambler]

Check in LD 15 that "19" isn't the SPRE code.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.net

linkedin

 

[KCFLHRC]

It may have not printed the DNB because you left the CUST Blank. Just try doing a DNB on the single digit 1

 

[techdgrubbs]

Ok, I tried to out 19, and it still gave me an error, but it worked this time! I'm not sure why it would throw that error even though it was actually "out". You guys rock! Thank you guys so much.