Hi
Attempting to completely wipeout my switch, I deceided to run erase commands, etc. All was going well until I ran erase NVRAM. Now I get the following;
"The system is unable to boot automatically because there are no bootable files to boot"
I get these messages beforehand;
The Flash initializes ok.
Boot sector FileSystem installed ok.
Parameter block Filesystem installed ok.
Running Cat2900XL-EN, ver 12.0(5.2)XU
How do I get back to my nice basic setup??
Thanks for any help, Steve
Attempting to completely wipeout my switch, I deceided to run erase commands, etc. All was going well until I ran erase NVRAM. Now I get the following;
"The system is unable to boot automatically because there are no bootable files to boot"
I get these messages beforehand;
The Flash initializes ok.
Boot sector FileSystem installed ok.
Parameter block Filesystem installed ok.
Running Cat2900XL-EN, ver 12.0(5.2)XU
How do I get back to my nice basic setup??
Thanks for any help, Steve