Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cannot Execute a Command with VT520 Terminal 1

Status
Not open for further replies.

VirtuaBoy

IS-IT--Management
Sep 29, 2011
9
US
We have been using a VT520 terminal to communicate with our PBX system. The other day I ran a large print and used the hold function a few times until I got a backwards question mark, and the print stopped.

We use OTM manager a majority of the time, but I've been using the terminal to do things we can't do in OTM. I assumed that OTM's daily task that night would override the frozen print command.

While the terminal did acknowledge the fact that a job was run from OTM (it read PDT in progress... DONE!), I cannot execute a command from the terminal itself.

I can type, but when I hit return... nothing.

Any suggestions?
 
I've already done that a few times. The system check is okay too.

I've also reset the communications, reset the session, all the way to a factory reset.
 
Do you have a virtual terminal session set up through otm so you can go into load 37 and stat the tty's
 
Ah. Nice. It was disabled. Thanks a lot for your help.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top