Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cannot enable msdl on PRI card on CS1000E Rls 5.5

Status
Not open for further replies.

iso30

Technical User
Dec 28, 2008
30
LB
Hi


We had an issue on a CS1000E Rls5.5 CPP4 pbx were on the media gateway holding the MGC ( 8 1) we programmed a PRI card (loop 127)and it worked fine (position 8 1 3)
we tried now to program another PRI card (loop 128) on slot position 8 1 4 but it is not working, when you put enable msdl ( enl msdl 8 1 4 fdl )
in ld 96 nothing happens, I have waited for 10 mins, have to type **** to return to the . state.

Any ideas??

Regards
 
I had a similar problem a couple of weeks ago. Try power cycling the MG once all the programming is done & edd. Worked for me. If that does work the other problem i noticed was you could up & down the MSDL with that config but if you changed the protocal you had to reboot again.. strange but have logged a case with Nortel

Remember if it doesn't work hit it harder

Scott UK
 
Can you post a Pswv in the forum.
The issue is similar to one occurred on my system. I solved by upgrading the MGC loadware.
 
hi

PAT# PRS/CR PATCH REF # NAME DATE FILENAME
00 see MPL ISS1:1OF1 MGCCAH19 15/11/08 MGCCAH19.LW
01 mgcmaa07 15/11/08 MGCMAA07.LW
02 MGCFAA14 15/11/08 MGCFAA14.LW
03 ISS1:1OF1 dsp2aa12 15/11/08 DSP2AA12.LW
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top