Cannot call individual DNs through IP trunk 2

[bashboosh]

Hi,
I have setup the BCM400 to call multiple BCM50s through IP trunk. I cannot make call to the individual DNS from my BCM400 to 50s and viceversa. Target lines are already set.
In the BCM400:
Dialing plan>Routes:
000 - Default route, Pool A
001 - Pool O, Private
Dialing plan>Destination codes:
8A, Route:001, Abs.1
IP Trunk rounting table contains two digit destination codes for each sites (Eg; 21, 22, 23, 24 ...etc)
Private network type is CDP

Now, When i try to call 82501 (8 is the dest. code, 2501 is the dn at a site), The AA answers immediately after the number 8250.

Anybody help me please to finish this setup? I will provide if any further information required.

Thanks a lot.

Now, When

 

[Dasheen]

How many digits r set for private rec'd?

 

[cook1082]

Also open the BCM monitors for the sites and see if you are sending and receiving the same digits.

 

[bashboosh]

Dasheen, The HO DN Length is 3 and all other sites are 4 digits. This will affect while calling from HO to other sites? Other sites are priv. recd set as 4, as i stated above. If the DN length is 3, still i can set the priv received 4? Please advise.

Anyhow, i will be changing the DN length to 4 in HO in this weekend.

Cook1082, I will open the Monitor on both side and update you shortly.

Thanks & Regards

 

[bashboosh]

Hi All, It did work. I have changed the last system also to 4 digit and it started working. I need a kind favor from you, Under Dialing plan, Private network, what does mean by Private network Id, VoiP Id, Zone ID etc? What are their effects if i set it?

Thanks

 

[Dasheen]

zone ID gets used when networking to a PBX w/ multiple remote sites.Each site gets put into its own zone.

 

[bashboosh]

So, Zone ID and Private network ID on a same site can be the same figures? I have multiple sites all are configured site 2 site VoIP, These settings are important to me? Can be reflected in voice communication negatively if not set?

Thanks again