If I wanted to change from a 2317 to a 2008 with an EZ Change, is that possible or do I have to OUT the DN completely and Rebuild using the 2008?
Thanks Travis
I am a newbie, so forgive me. I don't have any 2317 phones on hand, but I'm fairly certain that the phone is the problem. If I want to OUT the phone and rebuild it with a 2008 what would I need to do? Thanks for any help you can provide.
TRavis
ld 11
req=out
type=2317
tn=8 0 14 7
enter..
then find a 2008 you want your new set to look like.
ld 11
req=cpy 1
type=2008
cftn= (tn of simular set)
tn=8 0 14 7
check the new phone for key changes, des change hunt change etc.. or just repost the new tn and i'll give you sugestions
Thank You so much!. I have been at the Comp.dcom.sys.nortel newsgroup up til now and it's terrible as far as how long it takes for a post to show up. This forum is MUCH better. Thanks alot Travis
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.