Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Can I make test calls from a maintenance set through a T1 line

Status
Not open for further replies.

BStephens

MIS
Jun 20, 2005
35
US
I need to make test calls to verify if our T1 has been repaired. I know I can dial out over copper using the TN, but the digital T1 only has 2 sets of numbers.
 
Will not cause an issue, it only uses the channel you pick just like any normal call. If it happens to be busy it will not cut in to the call. Stat the cct in LD 60 just before you try to see what is available to use.
 
You can make a call from the maintenance set if it's a plain T1 but not if it's a PRI.
You can access a B-channel on a PRI via MTC set but the dial signaling on a PRI is through the D-channel so you won't be able to dial a phone number.
 
You can also change the Search to RRB and then dial the ACOD and you can march right through them

OLD ROLMEN WORKING ON NORTELS AND AVAYA
 
Not in a Multi-Group PBX - you can only march through members that are in your own network group

~~
Gene at www.GHTROUT.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top