Can CM3.X run on a TN2402 using a PROLOGIX...

[1ce]

Hi all,

The above question had been posed to me and I wondered if anyone has done this... I cant seem to find any supporting documentation for this theory..., I know you can have S8400 platform with SIPI in the Prologix but not sure about using a TN2402 and loading CM3.X via Flash card.

Anyone come across this design ?

1ce

 

[avayafreakje]

Well, there were some roumers that its possible to run cm 3.x on a blade tn2402 processor but it would be a different release than available. i guess avaya forces their customers to upgrade to a S-series server with this software release. Officialy its not possible to perform this action.

 

[nohuhu]

1ce,

cm3 does support csi platform (prologix) and does run on tn2402 processor. no problem with that.

 

[1ce]

dwalin,

Thanks for the reply... I think its confirmed.

1ce

 

[1ce]

Hey Everyone,
Another question on this topic...
If I'm going from a prologix R10 or R11 to CM3.1 would I require Provision for the migration via FLASH upgrade
Regards
1ce

 

[nohuhu]

1ce,

no you don't need provision in this case. after you reboot the system with new software you just insert a flash card with existing r10/r11 translations and it will be loaded up and converted automatically. prologix is easy to upgrade.

 

[1ce]

Thanks for confirming that for me...

Regards
1ce