Yes. Try adding cwa to the cls of the set. when you are on the call you should get an audible indication that there is another call than press and release the switch hook quickly to switch to the other call.
lhk 4 hnut to mail, other wise without key 4, you get hunt treatment during a ring cycle... but i wish i was in the Caribbean... bikini season is longer
Actually it's the hurricane season right now. Most the questions I ask on this forum have been as a result of work done by our telco. We've taken over all our PBX's and I'm just trying to clean up the database and make sense of ALL they've done.
John, so if somone calls 4940 and it's busy it goes to key 1 etc. (i.e. it hunts basically). On the phones at work there's a key labelled CallWait.
on an acd set, calls waiting makes sense.. not on a digital station that can have more then one line (2006,3902).. mcr keys all flash at the same time, when i'm on key 0 the next call rings and flashes key 1 and 2.. the scr is never used unless two calls hit at the same time
key 0 scr 4904
key 1 scr 54904
with cls hta hunt 000 (or mail) and lhk to 1, negates the need of call waiting keys.. post one of your sets and we can make a few sugestions
same season in south carolina.. here's a clean up tip most of us miss..
Code:
ld 117
inv generate midnight
that turns on the feature, then anytime you need
Code:
inv prt sets
that gives you the as-built as well as the actual type of each digital set in the switch.. they need to match,it also gives you missing phones, lost tn's and tn's someone just marked bad and didn't fix.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.