Can´t Login in M1 over E-Lan Adress! E-Lan isn´t working!!

[msg85]

Hi!

I´ve got a big problem!
I want to get traffic over the E-Lan adress, and also programm over the E-Lan!

In LD 117´can´t ping any other M1, also can´t ping the Gateway adress!

I´ve swaped the SSC with Daughterboard, but without any effect! Same fault !

I can Ping the Gateway from the ELAN adress from the Gateway from the Signalling Server, but not otherwise!

Pls can you help me!

Thx

 

[srmega41]

Have you enabled the route? Have you set your primary host to the new host address you built? These are also in LD 117.

Check LD 137 and STAT ELNK. Is the ELNK enabled and is the IP Address on the ELNK the right one? If not, disable the ELNK, and in LD 117 enable the host and route, then try to re-enable the ELNK in LD 137.

The gateway address usually resides on a router or on a VLAN'ed switch port. Pinging the gateway will only show the subnet is active, but will not get you to the PBX.

Hope this helps,

Scott M.

 

[msg85]

It´s an O11C! Transeivers ar checked and OK!

 

[msg85]

In LD 137 is all active! Route is OK! Host is also OK!

The Transeiver has an Link and only the Receivce LED is always flashing!

I don´t know anymore...

 

[srmega41]

Did you try and bounce the ELNK?

I have also had a few Opt 11's that required an INI before the ELAN came up, not sure why. I have 83 11's and an 81C all using the ELAN for communications, so I have seen a few wierd issues.

Good luck, and post back if this does not help. A PRT in LD 117 may also be helpful;

PRT HOST
PRT ROUTE
PRT GATEWAY

STAT HOST
STAT ROUTE 1 (or 0)

Hope this helps,

Scott M.

 

[msg85]

The strange thin is, that the settings are allright!

The Host has the right IP
The Route is OK
Gateway is OK

=> stat route
*** Active Internet Routing Table ***
ID Destination Gateway Port
1 0.0.0.0 172.xxx.xxx.xxx 0 [qu0]
=> STAT host
*** Active Internet Host Table ***
ID Hostname IP Address
-- localhost 127.0.0.1
4 SUCCESSION 172.xxx.xxx.xxx
1 SECONDARY_ENET 137.135.128.254
2 LOCAL_PPP_IF 137.135.192.4
3 REMOTE_PPP_IF 100.1.1.1

 

[msg85]

**UP**

 

[SL1User]

What about the subnet mask (LD 117) prt mask.
Is it correct?

 

[SL1User]

I have just printed out my working configuration.

=> prt elnk
ACTIVE ETHERNET: "NODE_NNCS" "192.110.48.88"
INACTIVE ETHERNET: "SECONDARY_ENET" "137.135.128.254"
OK

=> prt host
Call Server/Main Cabinet
ID Hostname IP Address
1 SECONDARY_ENET 137.135.128.254
2 LOCAL_PPP_IF 137.135.192.4
3 REMOTE_PPP_IF 100.1.1.1
4 NODE_NNCS 192.110.48.88
OK

=> prt mask
Call Server/Main Cabinet
SUBNET MASK: "255.255.255.0"
OK

=> prt rout
Call Server/Main Cabinet
ID Destination Gateway Port
1 0.0.0.0 192.110.48.1 0
OK