Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Calls from Optimum fail when going over cdp

Status
Not open for further replies.
thattekguy

thattekguy

Vendor
Feb 2, 2007
432
US
I have an asterisk system setup connected to my CS 1000m via CDP pri tie line. When calls come from Optimum into an Asterisk set they get re routed to the receptionist instead of going over the tie line. If I change the Tie between the Nortel and the Asterisk to SIP, then the calls go thru fine from Optimum. My DSEL on the PRI TIE to Asterisk is VCE, I was going to change it to 3vce and see if that helps..any ideas?
 
Status
Not open for further replies.

Similar threads

ashwincjoshi
  • Locked
  • Question
Issue with CDP Configuration on Nortel CS1000 - One Number Works, One Doesn't
Replies
1
Views
434
Firebird Scrambler
Firebird Scrambler
AlaskanTech
  • Locked
  • Question
I can make out going calls but incomming calls just keep ringing.
Replies
2
Views
216
bignose21
bignose21
krtcomm1
  • Locked
  • Question
CLID on tandem calls outbound to PSTN when calls are forwarded externally
Replies
6
Views
387
krtcomm1
krtcomm1
Emara
  • Locked
  • Question
when dialing the access code and th
Replies
1
Views
351
Firebird Scrambler
Firebird Scrambler
bltodd
  • Locked
  • Question
ERR008 Digital and Analog Calls in Hang up after initial connection. Calls to outside hangup Fax too
Replies
0
Views
256
bltodd
bltodd

Part and Inventory Search

Sponsor

Back
Top