CallPilot HyperTerminal Password

[marker2001]

I am working on a CP100 in getting it ready to sell on eBay.
I do not have a MICS or CICS in hte office currently to hook the CP100 to to access using the feature codes.

In the HyperTerminal window it offers me the ability to Login: but I do not have the login or password and searched on the internet and here have rendered me no success.

When booting the system does show the username and password of the PPP (IP) login but that does not work.

Does anyone know this login and password?
I am just trying to reset the system to default.

Thanks

 

[ptstechnician]

Don't think you can access the CP at all without it connected to a MICS or CICS. I would just sell the CP as is because anyone who buys it can hook-up a serial cable with hyperterminal to see what the IP address is.

 

[marker2001]

If I understand you correctly, even though the CP is offering a Login and Password and tells me I have the wrong Login name when I try to login, the system only let me login after the CP has successfully connected to a MICS or CICS?

I'll accept it, but it doesn't make sense.

- Mark

 

[norteltx]

You can't do anything with a CP100/150 unless it is hooked up to a Norstar port. Found out the hard way. Does seem a little deceptive.