Calling out on Magix E&M Line from a networked IP Office

[vpmol]

Hello everyone, I am looking for some help to get my calls to go out on existing Magix E&M Trunks. We recently converted a client to IP Office but they had old E&M Tie analog trunks. Since I learned that they aren't just regular TIE trunks from a carrier, but they go through a Cisco ISR I need to get an immediate fix until we can put in a T1 card into the Cisco.
I was able to connect the IP Office and Magix through a PRI point to point and when I try to send calls out through the Magix, the calls are ringing in to the Magix phones exactly how they normally would if the real PRI was in use (to a hunt group).
What I need help with is to send those incoming PRI calls out of their Existing E&M Trunks. Right now if I had the Magix hooked up, they dial 66 plus the number to dial over E&M Trunks.
I have read the Technical TIP 134 to network the Magix with the IP Office but I don't know enough about the Magix to get the calls to go out of the E&M Line.
I believe I need to configure the UDP routing and pattern number. Can anyone assist? Greatly appreciated.

 

[kwing112000]

Do you have trunk to trunk transfers enabled on the merlin? are you sending the 66 and the number over from the IPO. I did this a long long time ago and got it working. it was like 10 years ago.

Kevin Wing
ACSS Small and Medium Enterprise (SME) Communications
ACS- Implement IP Office
ACA- Implement IP Office
Vive Communications

 

[vpmol]

Kevin,
From what another tech explained, this can be done but only calling out of the PRI/T1 on the Magix. That I would not be able to call out the TIE E&M line even if I did get the UDP working. Do you happen to know if this is true? Thank you

 

[wireboy]

i think that the other tech may be in error. merlinman and ttt seem to understand a lot about this circumstance. you may be interested to see/hear their suggestions.

42