Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Calling out on Magix E&M Line from a networked IP Office

Status
Not open for further replies.

vpmol

Vendor
Mar 11, 2008
245
US
Hello everyone, I am looking for some help to get my calls to go out on existing Magix E&M Trunks. We recently converted a client to IP Office but they had old E&M Tie analog trunks. Since I learned that they aren't just regular TIE trunks from a carrier, but they go through a Cisco ISR I need to get an immediate fix until we can put in a T1 card into the Cisco.
I was able to connect the IP Office and Magix through a PRI point to point and when I try to send calls out through the Magix, the calls are ringing in to the Magix phones exactly how they normally would if the real PRI was in use (to a hunt group).
What I need help with is to send those incoming PRI calls out of their Existing E&M Trunks. Right now if I had the Magix hooked up, they dial 66 plus the number to dial over E&M Trunks.
I have read the Technical TIP 134 to network the Magix with the IP Office but I don't know enough about the Magix to get the calls to go out of the E&M Line.
I believe I need to configure the UDP routing and pattern number. Can anyone assist? Greatly appreciated.
 
Do you have trunk to trunk transfers enabled on the merlin? are you sending the 66 and the number over from the IPO. I did this a long long time ago and got it working. it was like 10 years ago.

Kevin Wing
ACSS Small and Medium Enterprise (SME) Communications
ACS- Implement IP Office
ACA- Implement IP Office
Vive Communications
 
Kevin,
From what another tech explained, this can be done but only calling out of the PRI/T1 on the Magix. That I would not be able to call out the TIE E&M line even if I did get the UDP working. Do you happen to know if this is true? Thank you
 
i think that the other tech may be in error. merlinman and ttt seem to understand a lot about this circumstance. you may be interested to see/hear their suggestions.

42
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top