Calling Number will not Appear???

[phoneaddict]

Hi,

I have two avaya switches connected via IP trunking. Both have CM 3.1.2 and S8300/G700. I have problems in sending out the calling number when someone dialed an extension going to my other site. They want to appear the name and the number of the person who is calling and vice versa. But still only the name of the station will only appear. How to set such that name and number will appear in the phone? Also, the name will only appear unless the call is engaged.

Here's my trunk group:

Group Number: 6 Group Type: isdn CDR Reports: y
Group Name: IP Trunk COR: 1 TN: 1 TAC: *06
Direction: two-way Outgoing Display? n Carrier Medium: H.323
Dial Access? n Busy Threshold: 255 Night Service:
Queue Length: 5
Service Type: tie Auth Code? n
Member Assignment Method: manual













Group Type: isdn

TRUNK PARAMETERS
Codeset to Send Display: 0 Codeset to Send National IEs: 6
Charge Advice: none
Supplementary Service Protocol: a Digit Handling (in/out): enbloc/enbloc

QSIG Value-Added? n
Digital Loss Group: 18
Incoming Calling Number - Delete: Insert: Format:

Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0









TRUNK FEATURES
ACA Assignment? n Measured: none
Internal Alert? n Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n Send EMU Visitor CPN? n
Suppress # Outpulsing? n Format: private
UUI IE Treatment: service-provider

Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: y
Hold/Unhold Notifications? n
Send UUI IE? y Modify Tandem Calling Number? n
Send UCID? n
Send Codeset 6/7 LAI IE? y






QSIG TRUNK GROUP OPTIONS








SBS? n












TRUNK GROUP
Administered Members (min/max): 1/10
GROUP MEMBER ASSIGNMENTS Total Administered Members: 10

Port Name Night Sig Grp
1: T00001 Channel01 1
2: T00002 Channel02 1
3: T00003 Channel03 1
4: T00004 Channel04 1
5: T00012 Channel05 1
6: T00013 Channel06 1
7: T00014 Channel07 1
8: T00015 Channel08 1
9: T00016 Channel09 1
10: T00017 Channel10 1
11:
12:
13:
14:
15:

 

[DAVIDPAYNE]

You have to setup DCS for that to work correctly.

 

[dufus2506]

What you appear to be missing is the Qsig signaling.

Qsig is the protocol used to package and deliver the calling name and calling number.

You might also lack DCS which both systems must have to deliver calling name and number as a native Avaya integration.

Carpe dialem! (Seize the line!)

 

[phoneaddict]

Thanks for the replies.

But I appreciate if you can give me steps on how to set DCS and Qsig. What particular parameters in trunk group that I need to activate?

 

[PhoneTekChick]

Try qsig on the trunk group. Change the trunk group, signal group protocols both to B at both sites.

 

[PhoneTekChick]

you also want to turn on qsig value added on the trunk group

 

[phoneaddict]

thanks. I will give it a shot.. I will keep you updated.