Calling across IP CCIS to the conference bridge at #411 oe #412 fails?

[LDthirtytwo]

I have an IPS as the hub with a conference bridge in it that is used by all the other sites, the access code is #411 & #412, the SV8100’s have no problem using the conference bridge but I’ve got an IPS connected via IP CCIS back to the hub with a span of conventional CCIS to another IPS and neither of these two IPS’s can access the conference bridge, when you call #411/2 you see DDD in the display but there’s no speech path.
Here are my questions: - Should I build a virtual in each remote IPS’s as #411/2 then CFW them across CCIS to a station at the hub that is CFW’ed to #411/2 , conference bridge at the in the hub? Is the problem sending #XXX across CCIS? How would you do this if you had this problem?

 

[belevedere]

Did this ever work? Is it a recent problem?

You could try the forward trick, however if this never worked then I would look at the CCIS LCR. Make sure that #XXX is set up in the tables.

Is the no speech path on the IP CCIS and/or the TDM CCIS link?

 

[LDthirtytwo]

Mr Belvedere
The site has been in for 6 months and this has never worked from this location. From Fire #1, an IPS with a TDM CCIS link to the hub it works, but not from Public Works an IP CCIS Span.
I found the following programming already done
200>B411
200>B422
8A4006>1>0061
2>0062
8A0061>1>06145 WHICH I CHANGED 06116 BECAUSE ALL THE STN-STN CALLS OVER IPCCOS USE THIS
8A0062>1>6245 ALSO CHANGED TO 06216 AS ABOVE
8A5061>100>9061
8A5062>100>9062
8A5061>167>061 I ADDED THE IP LCR PROGRAMMNG
8A5061>168>00001
8A5062>167>062
8A5062>168>00001
8A9061>0>B411
8A9062>0>B422
5B01>06100>192.168.040.005
5B01>06200.192.168.040.005
When I dial either code I see DDD in the LCD, I hear dail tone on #41 or #42, when I dial the last digit a 1 or a 2 I get a fast busy.
I took out the LCR back to 200 and did the following
200>B41 & B42>804
CM 11>051>B411, CM052>B422
E600>B411>88,97 & B422>88,98
At the hub the two virtuals 8897 & 8898 are both E600>XXXX>B411 & B422.
Now I get to the Conference bride, I set the name in the LCD but it RNA. Can I get the conference bridge to answer going in like this or must It be a trunk via LCR the way.
This is an IPS at Public Works, I’ve not looked at the IPS at Parking Garage that feeds through this.
Any Idea Mr Belvedere

 

[belevedere]

In CMD 200>B411, which LCR table is it pointed to.
Follow it up with CMD 8AA000, then,
Check the maximum digits table for 8A4006 (856). Make sure that # (B) is allowed for at least 4 digits.