Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Caller ID on SX200EL
- Thread starter ajfischer
- Start date
pandabear1
Technical User
on analogue or digital sets or both?
- Thread starter
- #4
To display on the analog sets, you will propably require additional and/or replacement hardware. Analog CLID requires a BCCIII with a maintenance Module attached, ONS/Class Enabled Cards and A purchasable option on your MOSS Sheet.
The POTS lines are the other sticking point. If your system is an ICP with CLASS trunk capability. Programming is relatively simple. Without an ICP however, you need the CLASS trunk cards for the Per Nodes. The POTS lines also have to be CLASS enabled from the Telco.
With the above 2 resolved, displaying on the sets is a simple matter of enabling the appropriate COS and System options.
*******************************************************
Consistancy... Is only a virtue when you're not a total screwup.
The POTS lines are the other sticking point. If your system is an ICP with CLASS trunk capability. Programming is relatively simple. Without an ICP however, you need the CLASS trunk cards for the Per Nodes. The POTS lines also have to be CLASS enabled from the Telco.
With the above 2 resolved, displaying on the sets is a simple matter of enabling the appropriate COS and System options.
*******************************************************
Consistancy... Is only a virtue when you're not a total screwup.
pandabear1
Technical User
why would you need a maintenance module on the BCCIII for CLID?
- Status
Similar threads
- Locked
- Question