Caller ID on all phones CICS

[thephoneboy]

I just installed a new CICS. with 6.1 software. with Caller ID line card. I know the older version you could only make the id come up automatically on one phoneand use F811 for the other phones. Can you make it come up automatically on all phones that ring with the new version? IF so how? Thanks

thephoneboy

 

[exsmogger]

Somewhere under Terminals & Sets there is a heading for Telco Features. You assign each line to show CID for the set selected in this area.

Brian Cox

http://www.jandjcommunications.com

 

[larrypoi]

brian has it
under term and sets
then to telco features
then to feature assign
show line ???

 

[NorstarWiz]

Of course you have to have the lines assiged to the phone in order to use "Feature Assign

 

[MarvO1]

An added note:
There seems to be some confusion over this,
BUT, CID has always worked on the CICS properly with all sets that are programmed properly as stated above. Even back to 1.0 software.

The MICS platform is the one one that would only show on 1 set, and need the F811 on additional sets.

MarvO said it