A few weeks ago my CS1000M lost power. When came back up everything appeared to be working fine until I started getting complaints that caller id was not working on CLASS phones. Some searching I discovered that both XCMC's were disabled; I went to enable them but would get NPR326. I disabled the loops and the controllers and brought them back up, which enabled the XCMC's. Still caller id is not working; so I replaced the card. Still not working; so I moved the card to another loop in a different network group. Was getting the same thing (NPR326), so I disabled/enabled the loop and controller, which enabled XCMC. Still not working, so I'm lost and need help. Any ideas/input is greatly appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Caller ID not working
- Thread starter LostTek
- Start date
- Status
Similar threads
- Locked
- Question