Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Call Routing with Dial-Peers and H323 Gateway

Status
Not open for further replies.

ifoam

MIS
Jul 4, 2007
76
US

There is my config.

I'm trying to configure this gateway so that only calls coming from extension 1258 will use dial-peers 500 and 501. Calls from any other extension will use dial-peer 100-103.

Right now, it seems like it doesn't matter that the calling number is, the same dial-peers are matched regardless.

Can anyone help?
 
Don't you have call manager? Change to mgcp and make it a lot easier on your self.
Are your FXS ports for the faxes on the same gw? if so put them in the same cor and try again.
 
whykap,

I justed figured it out. I used the following as a guide:


I tried using cor but it was not working properly. It seemed as if the COR restrictions were ignored. The config used this:

dial-peer cor custom
name restricted-pt
name unrestricted-pt
!
!
dial-peer cor list restricted-css
member restricted-pt
!
dial-peer cor list unrestricted-css
member unrestricted-pt
!
!
dial-peer voice 8312 voip
corlist incoming restricted-css
answer-address 8312
!
!
dial-peer v 911 pots
corlist outgoing restricted-css
destination-pattern 911
forward-digits all
port 3/0/0
!
dial-peer v 9911 pots
corlist outgoing restricted-css
destination-pattern 9911
forward-digits all
port 3/0/0
!
dial-peer v 7 pots
corlist outgoing restricted-css
destination-pattern 9[2-9]......
forward-digits all
port 3/0/0
!
dial-peer v 11 pots
corlist outgoing restricted-css
destination-pattern 91[2-9]..[2-9]......
forward-digits all
port 3/0/0
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top