Hello,
I have a setup where there is a Server Edition, and an IP500v2 with PRI's
They are all IP Phone and all of the users are built on the Server Ed.
Whats the best practice for routing these calls, I looked through avayas doc's and there really isn't anything that talks about this. Any advise on make it work better / easier would be appreciated.
Below is the config that I have set up and is working
I have the standard 9N / Dial / N / 50: Main shortcode
My Ars for 50 is N; / 8N / Dial / 99001 (SCN Trunk # to the IP500V2)
on the SCN Line I have a shortcode 8N / N / Dial / 50:Main
The ARS on the IP500v2 I have must of the standard ARS entries
XN / Nsi5555555555 / Dial 3K1 / Line Group 5(the PRI)
Thank you, Sean
EDIT: Version is 9.1.3
I have a setup where there is a Server Edition, and an IP500v2 with PRI's
They are all IP Phone and all of the users are built on the Server Ed.
Whats the best practice for routing these calls, I looked through avayas doc's and there really isn't anything that talks about this. Any advise on make it work better / easier would be appreciated.
Below is the config that I have set up and is working
I have the standard 9N / Dial / N / 50: Main shortcode
My Ars for 50 is N; / 8N / Dial / 99001 (SCN Trunk # to the IP500V2)
on the SCN Line I have a shortcode 8N / N / Dial / 50:Main
The ARS on the IP500v2 I have must of the standard ARS entries
XN / Nsi5555555555 / Dial 3K1 / Line Group 5(the PRI)
Thank you, Sean
EDIT: Version is 9.1.3
