I got reports that upon joining of other calls into conferences the far end hears static. this is from multiple people from multiple conferences. what would that possibly be. one to one calls are fine.
Generally it comes from an endpoint. Cell phone noise and bad connections would beard be heard by everyone in a call. Echo from a cell phone connection would also produce an echo for the entire call and everyone in it.
If it's just when any third party connects, I would check your network switch port settings. Make sure they're hard set for full duplex operation. Don't let them auto set themselves.
a caller in house here dialed into his audio bridge (outside provider), I then dialed into that bridge from a seperate line and I heard alot of static on my end. Nobody else heard it. Seems to be happening to a lot of users on all different types of bridges.
Have you tried different bridge services to see if it's the bridge?
Look for some free conferencing bridges so you can test without cost.
It might just be the service you're using.
It could also be associated with your outside line provider.
If you have T1's, check them by entering the command:
list measurements ds1 log xxxxx
where xxxxx is the T1 board location. If you see error seconds on the board, you might want to look into the configuration of the circuit, or the health of the DS1 board.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.