Call pilot programming via lap top

[johnnydeesp1]

I have a call pilot that was connected to the customers lan via 192.168.1.250. The customer put in a new Cisco switch and is no longer using this range for their ip addresses. I want to just be able to plug my lap top into the cp and program. Will I be able to use a cross over cable and log into the cp if I configure my lap top to be 192.110.1.10?

 

[phoneguy427]

Set your laptop to 192.168.1.240 , plug in your cable and access the cp with 192.168.1.250 , then you can change the address of the cp to whatever you want.

 

[johnnydeesp1]

You are the man! Worked perfectly.