Call Pickup from Trunk

[trtrtrtrtrtrt]

Hi
how i can pickup a call from trunk

i have two system, elastix (5xxx) and Siemens Hipath 4000v3 (2xxx), connected by SIP Trunk.


from Siemens, (77+Extension), Siemens extensions can pickup a call for other Siemens extension (only).
77+2xxx ----> OK
77+5xxx ----> Don't Work
Wabe (77 |. .**** ..**. ..... ..... .*| PUDIR)

from Elastix, (**+ Extension), elastix extension can pickup a call for elastix and Siemens extension,
**+2xxx ----> OK
**+5xxx ----> OK

i can pickup call dial (Siemens number) from (Elastix)
but i cannot Pickup call dial (Elastix) number from (Siemens)

what is wabe configuration needed for Siemens.

 

[sbcsu]

Hi,
This is not very clear.
Please explain more

 

[sbcsu]

So you have added more info...
You need to setup Pickup External.
Example:

ADD-WABE:8020,,,OWNNODE,N;
CHA-ZAND:TYPE=ALLDATA,PNODECD=8020;

REG-CGWB;
Change the CGWB of Link to the Other System as follows:
CHA-CGWB:CGW,3,1,LEGKDATA,,800100,YES; (Or what ever PEN the Trunk is on)
ADD-WABE:8001,,,STN,N;
CHA-WABE:8001,200; (Destno of other system)

ADD-AUN:302,,GR,2134,,,YES,ON3,YES,ALL,,,,,;
ADD-AUN:302,,GR,,800100,302,,,,,YES,YES,YES,,; (Pickup group on HiPath=302, Pickup group on other system=302)

Change the 'node number' on the other system to be 8001
When the Other System sends a pickup request it should send it to node 8020 (HiPath)

 

[trtrtrtrtrtrt]

<REG-CGWB;
S3: DATA SUBSYSTEM FOR AMO CGWB NOT FOUND ON HARD DISK

 

[sbcsu]

That may be correct.
What version of system do you have

 

[sbcsu]

I think you have a V3 ?
If that is the case - you will have to setup a new route to the other system.
Set it up with an access code of 8001 for example
Then in the LDPLN
ADD-LDPLN 8001-Z
In the Pickup group the other node is then reachable by 8001
ADD-AUN:302,,GR,2134,,,YES,ON3,YES,ALL,,,,,;
ADD-AUN:302,,GR,,800100,302,,,,,YES,YES,YES,,; (Pickup group on HiPath=302, Pickup group on other system=302, access code to other system 8001)