Users at a remote site are having an issue when trying to dial a specific area code. It is a DSN number so they have to press 8 to dial out first. They are trying to dial 8 311-xxx-xxxx but the dial tone cuts off after only dialing 8 311-xxx-x. This on on Opt 11c.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Call drops when dialing
- Thread starter PHANDL
- Start date
EddieDuece
IS-IT--Management
Can you post the programming for us?
- Thread starter
- #4
EddieDuece
IS-IT--Management
That's what I was thinking as well. Should be an easy fix.
1. Is this new or has it ever worked at Remote site?
2. Do you have 8 setup as your AC2? Is 8 the AC2 at the main site? You may just need to insert an 8 in the DGT/DMI at the remote site, so it can hit BARS again at the main site.
Can you print you NET data from LD 90 for 311, the RLI/RLB and DMI/DGT from Ld 86?
2. Do you have 8 setup as your AC2? Is 8 the AC2 at the main site? You may just need to insert an 8 in the DGT/DMI at the remote site, so it can hit BARS again at the main site.
Can you print you NET data from LD 90 for 311, the RLI/RLB and DMI/DGT from Ld 86?
- Status
Similar threads
- Locked
- Question
- Locked
- Question