All Patches and Service Releases are up to date, channels will disable then have to go in and re-enable them 1 at a time, but some channels will show loading re-enable them they still show loading but when tracing them they are working, Starts with 1 channel then goes up from there only way to clear them is to reboot call pilot.. Any answers to this issue??
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cal Pilot 5.0
- Thread starter Alabama16
- Start date
curlycord
Programmer
You did not respond (as well your other 2 posts):
Good luck!
________________________________________
Add me to LinkedIN
**New Allworx Forum**
=----(((((((((()----=
Toronto, CAN
Good luck!
________________________________________
Add me to LinkedIN
**New Allworx Forum**
=----(((((((((()----=
Toronto, CAN
- Thread starter
- #3
New to looking for help here and I actually forgot I posted the question after a reboot of the Call Pilot and Call Center seemed to clear the issues with that system.
have made a note about this post so I would not forget to reply,, Thank You
have made a note about this post so I would not forget to reply,, Thank You
curlycord
Programmer
I do not know your version but I had a good search and cannot see anyone having this issue with exception to one person other than you.
Think about backup and imaging the drive perhaps in case it is deteriorating.
________________________________________
Add me to LinkedIN
**New Allworx Forum**
=----(((((((((()----=
Toronto, CAN
Think about backup and imaging the drive perhaps in case it is deteriorating.
________________________________________
Add me to LinkedIN
**New Allworx Forum**
=----(((((((((()----=
Toronto, CAN
- Thread starter
- #5
- Status
Similar threads
- Locked
- Question