dirkfuzzbucket
Technical User
I have an BVP error at a remote site, I can't get there until next week. The Tie link keeps going down after erroring See below. I know I need to sort the fault out, but in the meantime I am dialling in every hour to reset the counters to stop the link going into maint or nnc.
Is there any way to automatically do this on the OPT11 or what counters in LD73 do I need to change to stop the link from going down?
PRI2 TRK LOOP 2 ATLP 0
% MNT NNDC NNC OOS
% BPV- 003 000 004 008
% FAP- 000 000 000 000
% SLP- 013 000 000 012
% CRC- 000 000 000 000
% G2 - 000 000 000 000
% MAINT NONEWCALL UNAVAIL SEVERE
% TOTAL 24HR BPV - 000000032 000000016 000000008 000000125
% TOTAL 24HR CRC - 000000006 000000009 000000000 000000000
% TOTAL 24HR FAP - 000000000 000000000 000000000 000000000
% TOTAL 24HR SLPREP - 000000000
% TOTAL 24HR SLPDEL - 000000364
% TOTAL 24 HOUR G2 AIS -000000000
% TOTAL 24 HOUR G2 LFAS -000000000
% TOTAL 24 HOUR G2 LMAS -000000000
% TOTAL 24 HOUR G2 RAI -000000000
% TOTAL 24 HOUR G2 LOS -000000000
% TOTAL 24 HOUR G2 RAIE -000000000
Is there any way to automatically do this on the OPT11 or what counters in LD73 do I need to change to stop the link from going down?
PRI2 TRK LOOP 2 ATLP 0
% MNT NNDC NNC OOS
% BPV- 003 000 004 008
% FAP- 000 000 000 000
% SLP- 013 000 000 012
% CRC- 000 000 000 000
% G2 - 000 000 000 000
% MAINT NONEWCALL UNAVAIL SEVERE
% TOTAL 24HR BPV - 000000032 000000016 000000008 000000125
% TOTAL 24HR CRC - 000000006 000000009 000000000 000000000
% TOTAL 24HR FAP - 000000000 000000000 000000000 000000000
% TOTAL 24HR SLPREP - 000000000
% TOTAL 24HR SLPDEL - 000000364
% TOTAL 24 HOUR G2 AIS -000000000
% TOTAL 24 HOUR G2 LFAS -000000000
% TOTAL 24 HOUR G2 LMAS -000000000
% TOTAL 24 HOUR G2 RAI -000000000
% TOTAL 24 HOUR G2 LOS -000000000
% TOTAL 24 HOUR G2 RAIE -000000000