Build# after SP1 Version 11.1

[shon4711]

Hello,

I tried to install SP1 on my 11.1 BAB. But it seems that it's not neccessary or already applied (the Service Pack won't install any of the options listed).
Where can I see if SP1-Level is allready included in my Version? Which Build Number I should see before/after SP1?

Thanks,
Peter

 

[speshalyst]

Hi,

On the BAB manager, go to Help and About..

it should show you Build 3100.. this is the build BAB gets to once Sp1 is applied..

So it Shall be Written!
So it Shall be Done!!

 

[shon4711]

Thanks speshalyst,

I had to re-install my 11.1. Version and then apply SP1.
First time I did run PreInstall.exe and that was my fault, because it turns version# back to 11.0. After this SP1 installed without probs.
And now I see Build 3100.

Best regards,
Peter