Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bring LSP into local mode and power off

Status
Not open for further replies.

avayabrain

Technical User
Apr 8, 2008
117
CA
We have 3 G700 and a S8500 which is remotely connected to s8720 at hub site?

We need to save translation(where do we run this command) and then poweroff all three G700 and S8500.

My understanding is that we run command " save Trans " on hub s8720 and then shut off G700 manually which will bring S8500 into local mode from LSP mode and use web interface to power off S8500?

is that correct or some thing iam missing?
 
I am not sure about the power down command but I know the translation. Go into 513 emulation (or GEDI) and type sa tra all (save translation all). This saves to all servers.

We did a reset system ## to reboot one of our PBX systems, but I am not sure a remote commnand to shut it down and power off. I think it runs a unix like environment, in unix it would be shutdown -h now (-h for halt and now for the time you want it to execute).

Hope this helps!
~Gary
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top