BRI Trunk problems

[Sennback]

We have an option 11c mini with 4 ISDN BRI systems connected.
Sometimes when I get status of the SILC card it gives the wrong status in the L1 column.
It should be UP, but is LCNR.
We are able to make calls, but when I tries to get the status command again, it takes a very long time to get the result.

We have changed both MISP and SILC, with no improvement at all...

Anyone who has experienced the same problem???

DSL L2 #TEI L1 D-CHANNEL RCVY CLK MODE
==== ==== ==== ==== ==== ========= ==== ==== ====
00 = BUSY TRNK ESTA -- LCNR ESTA AUTO PREF TE
01 = IDLE TRNK ESTA -- LCNR ESTA AUTO SREF TE
02 = IDLE TRNK ESTA -- LCNR ESTA AUTO TE
03 = BUSY TRNK ESTA -- LCNR ESTA AUTO TE
**************** L1 should be UP!! *******************

 

[johnpoole]

what do you have as a response to the mode prompt? the check mode may be a clue

john poole
bellsouth business
columbia,sc

 

[Sennback]

Mode is set to TE.
We have other meridians with BRI systems also.
They work fine and we have the same configuration in this case. There is only one small difference.
In this case they have only "general sevices" as feature set.